15.4.10
Sawing
Turn on the machine with the ON / OFF switch (9).
Remove the positioning knob.
The automatic feed to the saw arm moves automatically
downwards.
Do not apply pressure.
The saw automatically switches itself off after cutting the material
by triggering the off switch button.
Pull the saw arm into the air, and insert the positioning knob back in the hole.
THE TEETH OF THE SAW BLADE SHOULD GIVE THE MATERIAL TO BE CUT ALSO BE
ADJUSTED:
1. The thinner / narrower the workpiece, the higher teeth
2. Basic rule: it should be working at any given time at least 3 teeth in the material
NOTE: If the metal band saw a long time is not used, you can relax the saw band with the
adjustment of band tightening (10)
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
OPERATION
Positioning
knob
BS115 / BS128HDR
56