Adjusting The Vertical Bandsaw Blade Guide For Clippings - Holzmann BS 115 Betriebsanleitung

15.2.7 Adjusting the vertical bandsaw blade guide for clippings

Slightly loosen the left bandsaw blade
guide with the screw for fixation.
The tolerance by lowering the band saw blade guide leveling on bearing roll on the band saw
blade to zero.
Slightly loosen the nuts on either side guide
rollers with a wrench SW17.
After both bearing rollers are adjusted free of play, the two nuts tighten up the leadership
roles.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
With a wrench SW 12 is with the help of the
eccentric bearing roller according to externally or
internally displaced.
Repeat on both sides of the process until no play
between the bearing rollers.
The bandsaw blade should be centered on the
upper bearing role.
CAUTION: The two lower side rollers do not
clamp!
OPERATION
48
BS115 / BS128HDR