Select The Saw Blade Speed; Setting The Blading Speed; Setting The Feed - Holzmann BS 115 Betriebsanleitung

15.4.2 Select the saw blade speed

The saw blade is driven via a belt drive. Adjust the saw blade speed at the material to be cut.
Motor pilley
Select the feed according to the following table.
Material
Stainless Steel
Stainless Steel ®
Tool steel - Alloy steel
Bearing bronze
Structural steel - iron
mild steel - Thomas steel
Brass - Aluminium
Similar materials

15.4.3 Setting the blading speed

Open the lid by tightening the knob and the lid lift.

Now you can use the speed table in the lid to change the
cutting speed.
Turn the pulley easily and the V-belt in the provided disk groove screw.

CAUTION:
The V-belts must be connected to the opposite wheels

always in the same plane.

15.4.4 Setting the feed

The feed can be on the set screw on the Set hydraulic
lowering cylinder (4).
Select the feed according to the following table.
HOLZMANN MASCHINEN GmbH
speed
(m/min)
23
34
54
www.holzmann-maschinen.at
Driven pulley
Belt position
Motor pulley Drive pulley
A
B
C
OPERATION
Saw band
D Bi-Metal
E Bi-Metal
F HSS
BS115 / BS128HDR
54