Flash Counter - Hensel Integra Plus 1000 Bedienungsanleitung

13, 14
4:
FC
3:
AUDIO
14
HENSEL-VISIT GmbH & Co. KG
User manual // Integra Plus // Compact flash unit
be reduced by the same increments. The selected
operation mode for the modeling lamp is indicated by the
respective ON indicator. The modeling lamp is switched
OFF when no ON indicator lights up.
Dim mode
The dim mode is intended to prolong the life span of the
modeling lamp. If the modeling lamp level is adjusted to
FULL or to PROP between 10.0 and 9.1, the output is
dimmed automatically by approximately 1 f-stop after
having stopped working with the flash unit for longer than
35 minutes (default value). Pressing any button you like
switches the modeling light to the previously adjusted un-
dimmed level. If required, this default value can be
changed by entering a value from 5 minutes up to 95
minutes. For this purpose press button 13 twice and enter
the new value shown on display 14. Wait for 3 seconds
and the display changes to the flash power setting.
Flash Check
If this mode is switched on by pressing the FC button 4,
the modeling lamp is turned off after a flash and will turn
on after recharging to the adjusted power level. This
shows correct charge as well as readiness to flash. The
flash check mode guarantees that the flash heads have
triggered when more than one flash unit is used.

Flash counter

The data is read out of the flash counter by pressing the
AUDIO button 3 for approximately 3 seconds. the number
of flashes triggered appears on the LED display 14 as a
two-digit number:
the first digit shows the hundreds, the second digit the
tens. The units are truncated:
 display 05  number of flashes triggered between 50
and 59
 display 15  number of flashes triggered between 150
and 159
43