Hensel Integra Plus 1000 Bedienungsanleitung Seite 45

24
25
22
23
21a, 21b
30
26
HENSEL-VISIT GmbH & Co. KG
User manual // Integra Plus // Compact flash unit
Start-up and channel selection – transmitter –
The radio transmitter has no built-in main switch for
switching the unit ON. The transmitter is to be connected
to the camera either by attaching it to the hot shoe of the
camera or by connecting the camera to the synchro-
nization socket 24 using the provided synchronization
cable. If the transmitter is connected to the hot shoe the
unit must be tightened carefully using the locking screw
25. The working channel can be selected using the sliding
switch 22. There are 3 working channels available and the
option 'All'.
Flash triggering
Depending on the working channel selected the flash can
be triggered by pressing the 'TEST' button 23 or by
releasing the camera shutter.
In case of choosing the 'All' option on the transmitter, all
flash units are triggered independently from the working
channels selected.
Flash power adjustment and changing modeling light
options
The buttons 21a and 21b allow further options for Hensel
flash units with a built-in receiver. A single click on the
respective button reduces and increases the flash power
by 1/10 f-stop. Pressing button 21a for longer than 3
seconds switches the modeling light from FULL to OFF
and PROP, respectively.
The receiver is equipped with an interface socket 30 for
Hensel power packs.
Maintenance
The Hensel remote control system Strobe Wizard Plus is
almost maintenance-free. Because of the low energy
consumption of the transmitter a battery lifetime of 1 to 2
years can be assumed depending on the degree of
utilization.
The battery of the radio transmitter can be exchanged by
unscrewing screw 26 at the bottom of the unit. This
provides access to the electronics and the battery can be
removed from the clips and exchanged.
45