Replacement Of Modeling Lamp; Replacement Of Flash Tube - Hensel Integra Plus 1000 Bedienungsanleitung

HENSEL-VISIT GmbH & Co. KG
User manual // Integra Plus // Compact flash unit
Make sure that the modeling lamp corresponds to the
mains voltage.
Wait until the modeling lamp has cooled down, and then
remove the glass dome carefully from the unit by pulling it
out of the spring mechanism (see page 38-39) and
moving it straight away without touching modeling lamp or
flash tube (danger!). Handle halogen lamp with care. Pull
out halogen lamp and replace the modeling lamp with a
new one.
Avoid handling the modeling lamp with your bare
hands to prevent contaminating the modeling lamp
with the oil of your skin. This would reduce the
operational life of the modeling lamp. Please use
cotton gloves.

Replacement of flash tube

All unit types of the Integra Plus series are fitted with a
user-replaceable flash tube.
For replacement of flash tube switch the unit off,
separate it from the mains outlet and wait for at least
15 minutes.
Then remove the glass dome from the head carefully by
pulling it out of the spring mechanism (see page 38-39)
and moving it straight away from the head without
touching modeling lamp or flash tube (danger!).
Handle flash tube with care.
Avoid handling the flash tube with your bare hands to
prevent contaminating the flash tube with the oil of
your skin. This would reduce the operational life of
the flash tube. Please use cotton gloves.
Should the glass body of the flash tube be broken, do
not touch the electrodes under any circumstances! In
this case, use a fully insulated pair of pliers to remove
the damaged flash tube.
First unwind the ignition cable from the connection pin or
the ignition. Then pull out flash tube and replace it with a
new one. Finally connect the ignition cable.
49