Hensel Integra Plus 1000 Bedienungsanleitung Seite 33

HENSEL-VISIT GmbH & Co. KG
User manual // Integra Plus // Compact flash unit
 Do not route cables across the studio floor if possible,
so that damage is excluded. If routing across the studio
floor cannot be omitted, then it must be ensured that
vehicles, ladders, etc. do not damage cables.
Damaged cables and cases must be replaced
immediately by customer service.
 Ventilation slots of compact flashes must be kept free
during operation and sufficient air supply must be
ensured. Do not stick any objects into ventilation slots
or synchronization sockets. Do not deposit any objects
(tools, coffee cups, etc.) on the flash unit.
 Flash systems must not be used in environments with
explosion hazard. Flammable materials, like furnishing
fabrics, paper, etc. must not be stored in the immediate
vicinity of compact flash units to prevent fire hazards.
 Protect the equipment from moisture (including snow
and ice), dripping or splashing water.
 Choose safe locations for set-up of the equipment and
make sure that the equipment cannot fall into pools or
bodies of water. Never run cables directly along or
even through pools or bodies of water.
 Do not connect accessories from other manufacturers,
even if they use the same or similar connectors.
 Flash units - hanging from pantographs or ceiling -
must be doubly secured against falling down.
 Do not flash into eyes at short distances (smaller than
5 m) because this can lead to eye damage. Do not look
directly into the flash reflector.
 Regularly air closed rooms to prevent build-up of
inadmissible ozone concentrations, which can occur
due to the use of high-powered flash systems.

During work in the studio generating much dust, the
appliance must be covered with suitable dust pro-
tection (not during operation).
33