Hensel Integra Plus 1000 Bedienungsanleitung Seite 47

User manual // Integra Plus // Compact flash unit
Channel selection for one work station:
Please set all flash units used to light the set to C-
channels in order to trigger the automatic, synchronized
flashing of these units when using the freemask
application. The freemask compact flash units used for
lighting the mask have to be set on channels F1, or F2, or
F3. The slave of the freemask compact flash units must
be turned off to avoid their triggering by the first flash
group. The slaves of all other flash units can be turned
on. Exclusion: Speed Max. They offer too short recycling
times.
The freemask transmitter can be set to channel ALL.
Channel selection for several work stations:
If several separate work stations are set up within the
range of the radio remote control, the following
configurations can be selected: matching channels have
to be assigned to all flash units of both work groups and
of the freemask transmitter (e.g. C1 + F1 for work station
1, and C2 + F2 for work station 2, and C3 + F3 for work
station 3).
Camera settings:
If your camera supports these settings, use the following
settings for the freemask application:
1. Speed of picture series to fastest setting.
2. Number of exposures to two.
This ensures the setting to highest picture frequency with
two succeeding exposures (depending on camera).
The transmitter will then trigger the flash group 1 (C1, C2,
and C3) for the set lighting and the flash group 2 (F1, F2,
and F3) for the mask lighting, during the two camera
exposures.
At present, all cameras are supported with picture series
speeds from 3 pictures per second to (in theory) 500
pictures per second.
The transmitter automatically defaults to one picture after
200 ms. This is not dependent on the actual number of
exposures. This ensures that the set lighting is always the
first exposure and the mask lighting the second exposure
when using the freemask application.
47
HENSEL-VISIT GmbH & Co. KG