Acclimatizing; Positioning; Fixing Of The Glass Dome - Hensel Integra Plus 1000 Bedienungsanleitung

User manual // Integra Plus // Compact flash unit
19
20
16
18
17
38
Heating
Due to the modeling lamp and flashlight, each compact
flash unit emits heat. This can heat the parts of the unit up
to a dangerous level. Therefore make sure that the flash
unit is located far enough from inflammable props to avoid
inflaming them.
Take care for sufficient air supply and make sure that
ventilation slots of compact flash units are kept free. Do
not operate flash units unattended. The modeling light
should never be used for lighting up the studio but only as
assistance when focusing or determining the light guiding
and shadow details of the flash.

Acclimatizing

When moving the flash unit from one climatic zone to the
next, the appliance should stand in the room, in which it
will be operated, for some time before starting it up. This
prevents possible surface leakage currents due to con-
densing water.

Positioning

Integra Plus compact flash units come with a tilting head.
The unit can be attached to a stand or pantograph by
using one of the two holes and safely secured by
fastening the locking screw 19. The angle of inclination
can be adjusted using the fixing bracket 20. In the hole 16
above the fixing bracket an umbrella can be inserted and
fastened using the clamping screw 18. To hold even
heavy loads it is advisable to find a new optimal position
for the tilting head within the gliding rail. For doing this,
unscrew the Philips screw 17 and slide the tilting head
within the rail until the weight is balanced and finally
tighten the screw.

Fixing of the glass dome

Attention:
The glass dome should only be fixed or removed after
having switched the unit off and unplugged from the
mains outlet. Please take care not to damage either
the flash tube or the modeling lamp (danger!).
HENSEL-VISIT GmbH & Co. KG