Santec SLM-1040N Bedienungsanleitung Seite 36

7. Source:
To switch the video inputs, please use the IR remote control included in the delivery
(please also see page 36).
This button is also used as „OK" and „Confirm" function in the OSD menu.
Note:
If you need to press the source button several times, please make sure not to do this
too fast but to wait approx. 3 seconds between each button pressing. Otherwise, the
source button may not work properly.
8. OK / Menu (not used for SLM-1040N and SLM-1210N):
Press this button to call-up the OSD menu.
This button is also used to exit the OSD menu.
This button can also be used to return to the previous menu item.
9. Select ▲/▼:
Directional buttons up/down.
10. Display:
Press this button to call-up screen information such as resolution, signal source, etc.
11. Picture:
Press this button to toggle between the different picture modes:
User, Standard, Movie, Vivid.
12. PIP:
Press this button to select the picture-in-picture function. Define the size of the sub-
picture:
Small, Medium, Large, POP full, POP 4:3, Off.
13. Swap:
When in PIP mode, press the swap button to switch the main picture and the sub-
picture. The swap button is only active if you have defined a sub-picture before (see
above).
14. Position:
When in PIP mode, press the position button to define the position of the sub-picture:
Either in one of the four screen corners or centered.
15. Sleep:
No function.
_________________________________________________________________________________
SLM-1040N, SLM-1210N, SLM-1500N, SLM-1710N, SLM-1910N, SLM-2400HD
- 36 -
Bedienungsanleitung / User manual