Herunterladen Diese Seite drucken

Standing Installation; Hanging Installation - Bio Green Phoenix 2.8 Gebrauchsanweisung

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
Aircirculation Heater Phoenix 2.8
5. Installation
The electrical applaince may only be operated from earth leakage protected sockets! Before operating
the apparatus, ensure that this is the case for the socket to be used. Make sure that the maximum
current is not exceeded when the outlet has more than one socket or when using extension chords.
cable reels must always be fully unwound.
Ensure that the air circulation heater is disconnected from mains before or during installation. Select a
place for installation where the apparatus will not be exposed to rain or may fall into water.
Route the connecting cable such that it will not be a stumbling hazard, cannot be crushed or come into
contact with hot objects. Use only extension leads matched to the power rating of the apparatus and
complying with the applicable safety regulations. Do not wind the connecting lead around the
apparatus and never operate the apparatus with a coiled lead.

Standing installation:

To use the PHOENIX 2.8 air circulation heater as a floor mounted apparatus, the supplied feet must
first be fitted.
The following supplied components are required for assembly:
2x PHOENIX feet
4x self tapping screws
4x serrated washers
Have a Phillips screwdriver at hand.
The PHOENIX heater comes with pre-drilled holes in the housing for attaching the feet. Fasten the
feet here, using the self tapping screws with serrated washers (see illustration on Page 3).
Your PHOENIX air circulation heater is now ready to use as a floor-mounted apparatus.

Hanging installation:

To use the PHOENIX 2.8 air circulation heater as a hanging apparatus, the supplied chains must first
be fitted.
The following supplied components are required for assembly:
2x PHOENIX hanging chains
2x V-hooks
The PHOENIX heater comes with metal lugs on the housing to hook the chains, using the snap hooks.
The other two snap hooks then hook into the V-hooks. These V-hooks are then fastened to the profiles
in your greenhouse (see illustration on Page 3).
Your PHOENIX air circulation heater is now ready to use as a hanging heater.
13

Werbung

loading