Defrosting, Cleaning And Maintenance; Automatic Defrosting - Vestfrost FZ ... W Serie Bedienungsanleitung

Defrosting, cleaning and maintenance

Automatic defrosting

The wine cooler is defrosted automatically.
Defrost water runs through a pipe and is
collected in a tray above the compressor
where the heat generated by the compres-
sor causes it to evaporate. The defrost
water tray should be cleaned at intervals.
Cleaning
Before cleaning the appliance, unplug it
from the main supply. The cabinet is best
cleaned using warm water (max. 65°C) with
a little mild detergent. Never use cleaning
agents that scour. Use a soft cloth. Rinse
with clean water and dry thoroughly. The
defrost water channel, in which condensa-
tion from the evaporator runs, is located
at the bottom of the rear inside wall of the
cabinet and must be kept clean. Add a few
drops of disinfectant, e.g. Rodalon, to the
defrost water drain a couple of times a year,
and clean the drain using a pipe cleaner or
similar. Never use sharp or pointed imple-
ments. The sealing strip around the door
must be cleaned regularly to prevent discol-
ouration and prolong service life. Use clean
water. After cleaning the sealing strip, check
that it continues to provide a tight seal. Dust
collecting on the condenser on the rear of
the cabinet, the compressor and in the com-
pressor compartment is best removed using
a vacuum cleaner.
Replacing the light tube
Before replacing the light tube, unplug the
appliance from the main supply. Remove
the lamp cover using a small flat-headed
screwdriver. Replace the PLC tube (11 W).
Refit the lamp cover, reconnect the power
supply and start the appliance by pressing
the on/off switch.
11
GB
fig. 10