Operating The Receiver; Switching The Receiver On/Off; Setting The Brightness - switel BCF805 Bedienungsanleitung

5 Operating the Receiver

Check the transmitter and receiver are working properly each time before the equipment is
put into operation.

Switching the receiver on/off

1. Set the On/Off switch to position I". The Power LED lights up green. The receiver is now ready
to operate.
If the battery power becomes too low, the LEDs light up alternately.
2. To switch the receiver off, set the On/Off switch to position O".
Setting the volume
Press the 5 button to increase the volume.
Press the 6 button to lower the volume.
Set the required volume.

Setting the brightness

Press the button once.
MENU
Press the 5 button to increase the brightness.
Press the 6 button to reduce the brightness.
Set the required brightness.
Setting the contrast
Press the button twice.
MENU
Press the 5 button to increase the contrast.
Press the 6 button to reduce the contrast.
Set the required contrast.
Remote function
You can switch the monitoring function on and off manually by pressing the relevant button on the re-
ceiver.
If no picture is transmitted, press the
transmitted from the room being monitored and the picture currently being viewed by the lens appears
in the display.
If no voice or sound is detected for longer than one minute, transmission is automatically inter-
rupted.
If you want to stop transmission before the minute has expired, press the
stem then returns to Standby mode.
button. Approx. one second afterwards, the sound is
REMOTE
Operating the Receiver
button again. The sy-
REMOTE
43