Steps For Connecting Your Radio To Your Wireless Network; Connecting To Network - DNT IP-dio Bedienungsanleitung

Steps for connecting your radio to your wireless network

Power up the radio
Reciva Radio
ARM Powered
Initialising
Network
< Scan for networks >
Enter network
View Confi g
Edit Confi g
Scan for a wireless network connection
Scanning
No networks
Found
< My Home Network >
Connect to the wireless network
Connecting to
network
First, connect to the AC Power. In use, the radio can be switched on or off
with the standby button.
The display on the front of the radio will light up and say:
After a few seconds, this will change to show:
After a few seconds, this will change to show:
When the display says <Scan for networks>, press the SELECT button.
(Note: if you make a mistake at any point, press the BACK button to go back
to the previous screen.)
The radio will now scan for all available wireless networks and will display:
If it can't fi nd one then the display will say:
If this happens then you will have to get your wireless access point working
- see the instructions supplied with it.
When the radio fi nds your wireless network, it displays the ESSID for the
access point on the screen - this is a name that is allocated to the access
point by the person who set up the network - for example:
It is possible, and in some locations highly likely, that your radio will fi nd
more than one wireless access point, in which case you can choose which
one you want to connect to. Turn the knob on the radio to see the ESSID for
each access point the radio has found.
When the ESSID for the access point you want to connect to is displayed
on the screen, press the SELECT button.
If your network is not confi gured to need an encryption code, the screen
should say:
- 25 -
Operating