Choosing A Radio Station To Listen To; Search A Station; Listen To The Fm Radio; Using The Product - DNT IPdio Tune Bedienungsanleitung

Using the product

Choosing a radio station to listen to

Search a station (located in the menu item stations)
You can directly connect the radio to a station using the search function. The display shows the characters in
the 1st line and the input field in the 2nd line.
Rotate the SELECT button until the 1st character is locatate in the middle of the display and press the
SELECT button. Repeat this procedure until all characters are shown in the display.
Finally rotate the dial to select END und press press the SELECT button.
Now the display shows a list of stations.
Select the Station you want to listen to in the list and press the SELECT button to confirm.
It doesn't matter, if you use lower and upper case characters for the search string. If you make
a mistake at any point, press the BACK button to edit the last character.

Listen to the FM radio

In order to switch the radio from Internet radio, you need to select the Tuner in the menu list, the radio will then
automatically tune to the nearest station.
With <Station> the highlighted menu, press the SELECT button.
If the screen does not display<stations>, rotate the dial until it does and
then press the SELECT button.
Rotate the dial to choose from <Location>or <Genre>.
<Location>enables you to choose a station from a particular country.
<Genre> enables you to choose radio stations according to their content,
for example 90s, Classical, Dance or Rock.
Press the SELECT button to choose the option you want.
The display will show the number of stations that are loading. The 1st sta-
tion name will be displayed – stations are listed alphanumerically.
Press SELECT key for the stations you would like to listen.
The display will show <Station Selected Buffering x%> while the station are
buffering.
When you are listening to a particular station, the following information will
show on the display:
For example:
BBC Radio 1: Station Name
32 kbps WMA: Transmission Information
Real Enabled: Media player capabilities
On the top line of the display is current station name of frequency, and the
radio can display the RDS message if the RDS is available.
It is possible to switch between stereo and mono mode, this is helpful if you
are listening to a poor FM signal.
To switch between mono and stereo, press SELECT button, then you will
see mono when you are listening to stereo or stereo when you are listening
to mono, to toggle between each mode just press the SELECT key again.
- 35 -
Using the product