DNT IP-dio Bedienungsanleitung Seite 36

Operating
Use this option to download new fi rmware for the radio from the Reciva portal on the Internet. If there is
new fi rmware available, then the radio will prompt you if you want to download it or not. Note, at this stage,
you can press the radio's BACK button to cancel the radio beginning a fi rmware upgrade. A Firmware
upgrade may take several minutes, so do not switch off the power to the radio until the operation is com-
plete otherwise the radio may become permanently damaged.
<Language>
Allows you to change the display language.
<Factory Reset>
Puts all the settings back to their defaults as they were when they left the factory. If you perform a factory
reset on your radio you will lose all your presets and your wireless network connection.
<Register>
This will display a key that can be used to register the radio on the Reciva Customer portal:
http://www.reciva.com/
<Clock>
Use this option to set the time, to set an alarm and to view the current alarm setting, see "Setting the
alarm".
<Sleep Timer>
Selecting this option will enable the Internet radio to switch itself off after a set period.
After selecting the 'Sleep Timer' menu item, the radio will display: 'Sleep Timeout' and the sleep timer value
in the form '00:00:00' (hours:minutes:seconds) in 30 second increments.
Rotate the knob to change to sleep timer value and then press SELECT to begin the sleep timer.
The radio will continue to play as normal, but it will go into standby mode after the sleep timer has
expired.
To turn the radio back on again, simply press the ON / OFF button.
<Backlight>
Selecting this option will alter the Internet radio's backlight values.
After selecting the 'Backlight' menu item, the radio will display its list of three menu modes: 'Inactive',
' Active' and 'Standby'. These three states are explained below:
· The radio gets into its 'inactive' state when there is no user activity for 30 seconds.
· The 'active' state is when there is user activity.
· 'Standby' is the state when the radio has been turned off.
Rotate the knob to highlight the desired menu mode and press SELECT.
The radio will now display the current backlight value for this menu mode. You can alter this value by rotat-
ing the knob to increase or decrease it.
- 36 -