Troubleshooting; Specifi Cation - DNT IP-dio Bedienungsanleitung

Troubleshooting

If you experience any trouble with your wireless Internet radio, then you may fi nd it useful to visit the help
section on webpage: http://radio.reciva.com/
If you have trouble connecting the radio to your wireless network, these steps may help to resolve the
problem:
Confi rm that a Wi-Fi connected PC can access the Internet (i.e. can browse the web) using the same
network.
Check that a DHCP server is available, or that you have confi gured a static IP address on the radio. To
confi gure the DHCP, you must read the instructions supplied with the wireless access point.
Check that your fi rewall is not blocking any outgoing ports. As a minimum the radio needs access to UDP
and TCP ports 80, 554, 1755, 5000 and 7070. To confi gure the Access Port Control, you must read the
instructions supplied with the wireless access point.
Check your access point does not restrict connections to particular MAC addresses. You can view the
radio's MAC address using the menu item Confi gure -> Network Confi g -> View Confi g -> MAC address.
If you have an encrypted network, check that you have entered the correct key or passphrase into the
radio. Remember that text-format keys are case sensitive.
If your radio can connect to the network successfully, but is unable to play particular stations, it may
be due to one of the following causes:
The station is not broadcasting at this time of the day (remember it may be located in a different time
zone).
The station has reached the maximum allowed number of simultaneous listeners.
The station is not broadcasting anymore.
The link on the radio is out of date.
The Internet connection between the server (often located in a different country) and you is slow.
Try using a PC to play back the stream via the broadcaster's web site.
If you can play back the station with a PC, use the form at
http://www.reciva.com/stations/add_station.asp
to notify us so that we can change the station data that is used by the radio
Specifi cations
Power Requirements-Mains AC 230 volts, 50Hz only
Power Consumption: 20W
Speaker Output Level: 4.5W
Headphone Speakers Level: 15mW
This product is intended to be used in all European member countries, however there are restrictions when
used with France. See your countries relevant radio authorities website for details.
Hereby, dnt GMBH, Dietzenbach, Germany, declares that this IPdio is in compliance with
the essential requirements and other relevant provisions of Directive 1999/5/EC"
- 37 -
Operating