Geutebruck VIPCAM-GNSD882 Installationsanleitung Seite 142

MOTION
Motion Detection function allows detecting suspicious motion and triggering
alarms when motion volume in the detected area reaches/exceeds the
determined sensitivity threshold value. The main menu is shown below:
ALARM DETECT
DETECT SWITCH
DETECT MODE
BLOCK MODE
FRAME SET
FRAME DISABLE
THRESHOLD
EXIT
• BLOCK MODE
In Motion Detect Mode, users can set Block Mode as "ON" or "OFF". When
BLOCK MODE is turned on, if there are any variations (e.g. caused by
intrusion) in the sections of the monitoring image, the affected parts wiII be
high lighted dynamically.
• FRAME SET
In a monitored field, users can define specific areas as motion detection target
zones. Please refer to the instructions as follows to configure parameters for
each motion detection zone so-called "Frame". When motion is detected
within a defined frame, a flash warning notice: MOTION wiII display in the
upper left corner of the screen.
Totally 4 frames can be set. Select a frame using the joystick right/left and
press "ENTER" to enter the frame's submenu, as shown below.
FRAME SET 1
LEFT LIMIT
TOP LIMIT
HSIZE
VSIZE
MODE
PRESET POINT
DWELL TIME
EXIT
LEFT LIMIT
Move the frame right/left using the joystick right/left.
TOP LIMIT
Shift the frame up/down using the joystick right/left.
ON
MOTION
ON
01
01
016
YES
L/R
D/U
-/ +
-/ +
PRESET
001
001 SEC
YES
66