Geutebruck VIPCAM-GNSD882 Installationsanleitung Seite 135

• SELECT MODE
Select one of the modes that the dome should execute when the HOME
function is enabled and the RETURN TIME expires. The options include
<AUTOPAN>, <SEQUENCE>, <CRUISE> and <PRESET>. Use the
joystick left/right to change the setting and the items below will change in
cooperation with your selection.
• PRESET POINT
Select a preset point where the dome should go after the Return Time
function, which wiII be mentioned later, is activated. The preset point(s)
should be set prior either in the PRESET setup menu or via joystick.
SEQUENCE LINE
Select a sequence line that the dome camera should execute after the Return
Time function is activated. The sequence line(s) should be defined prior either
in the SEQUENCE setup menu or via joystick.
AUTO PAN LINE
Select an autopan line that the dome camera should execute after the Return
Time function is activated. The autopan line(s) should be defined prior either
in the AUTOPAN setup menu or via joystick.
CRUISE LINE
Select a cruise line that the dome camera should execute after the Return
Time function is activated. The cruise line should be defined prior either in the
CRUISE setup menu or via joystick.
• RETURN TIME
The dome starts to count down RETURN TIME when the dome idles and then
execute the SELECT MODE function when the return time is up. The
RETURN TIME ranges from 1 to 128 minutes.
GO
If HOME function is enabled, users are allowed to execute HOME function
by selecting this item.
59