Automatic Power-On; Use With The; Using The  Without Wire Stand - T+A CM Active Betriebsanleitung

Using the automatic
power-on circuit

Use with the

 
Using the 
without wire stand
The  loudspeakers are fitted with an automatic power-on circuit which
turns the speakers on from stand-by mode when a music signal is present, and
turns them off again about ten minutes after the music has ended.
The automatic power-on circuit can only work if the mains switch on the back
panel is at the ON position (position 1).

The power consumption of the loudspeakers in stand-by mode is very low (less
than 1 Watt).
If you know you will not be using the speakers for a long period, disconnect
them completely from the main supply.
If your pre-amplifier features switched mains outputs, the speakers can also be
connected to them and operated in this way.
If you connect the speakers to a 
 can be switched on by a trigger signal from the
the loudspeakers are always switched on with the
music starts. This eliminates the possibility of "swallowing" the initial beats of
the music.
Necessary settings in the 'System Configuration menu' of
Please select the following settings in the System Configuration / Loudspeaker

's:
menu of the
Switching voltage:
Loudspeaker:

(for details see the
If you don't want to install the  speaker on the wire stand, please
close the mounting holes at the bottom side by the selfsticking felt slide washers
supplied with the speaker!
13

On
Caruso + External
( as L/R speakers,

External (only ,
operating instructions)
Multi-Source System, then the

. In this case
 – not just when the


as Centre)
is muted)