Pc Application Software; What The Application Software Will Do; System Requirements; Installation Of Software - PeakTech 1890 Bedienungsanleitung

8.3. PC Application Software

8.3.1. What the Application Software will Do

The application software can perform:
* Timed Programming;
* Preset Programming;
* Data Logging;
* Voltage, Current and Upper Voltage Limit Settings.

8.3.2. System Requirements

* CPU 450 MHz or above
* 128 MB Ram
* Min. monitor screen resolution: 800 x 600 pixels.
* Operating systems: Windows XP, ME, 2000, 98SE, 98
All brand or trade names are trademarks or registered trademarks of their respective
companies.

8.3.3. Installation of Software

1. Place the provided installation disc in your CD Rom Drive and run setup.exe.
2. Follow the instructions in the setup program.
NOTE
During the running of the setup program, you may encounter "VERSION CONFICT" remarks, ignore it
and click "YES" to complete the installation.
3. A SDP icon is created in the Program Menu.

8.4. Running the application software for RS-232 Interface

NOTE
Before running the application software, you must have installed and connected your power supply to
the PC using the provided RS-232 cable.

8.4.1. Start-up the Application Software for RS-232

1. Ensure your PC is OFF, connect RS-232 cable to the serial port of your PC and the power supply.
2. On your power supply, press the [SHIFT] key, then quickly press [RS232/485] key and select RS-
232 followed by [ENTER] key.
3. Switch on your PC and run the SDP program.
4. Click on Setup, and select the desired COM Port. The default is set at COM 1.
Fig. 8.4.1a.
5. Click on Supply Connect, then click on Single in the drop menu.
6. An 'Internal Timed Program" Window will appear as shown in Figure 8.4.1b. Click on the Data Log
header on top right and a Data Log Window as shown in Figure 8.4.1c will appear.
Fig. 8.4.1b. Internal Timed Program Header
-41-