Resetting The Display; Operation Via A Computer; Setting The Interface; Entering A Message And Transferring It To The Display - IMG STAGE LINE PML-60R Bedienungsanleitung

4) To change the address, press the button [ ].
Press the button [ ] or [ ] to adjust a digit (hexa-
decimal) or press [ ] or [ ] to go to another
position. Press [ENTER] to confirm.
5) Press [ESC] to exit the setting menu.
The setting can be cancelled at any time with
[ESC].

4.1.7.4 Resetting the display

All display settings can be reset to their factory set-
tings. This will delete all messages, display pro-
grams and settings the user may have defined. The
clock setting and the unit address, however, will be
kept.
1) If the date / time display is active, press the but-
ton [ESC] to deactivate it.
2) Press the button [FUNCT]. "SETUP (
displayed.
3) Press [ ]. "CLEAR ALL Y?" is displayed.
4) To reset to the factory settings, press [ENTER]
or, to cancel the procedure, press [ESC].

4.2 Operation via a computer

Start the control program NewSign [...].EXE on the
PC. The window "Sign Color" (
1) Select the display type used:
TRIPLE COLOR for PML-100COL/-70COL or
SINGLE COLOR for PML-100R /-60R.
2) If this selection shall not have to be made every
time the program is started, remove the tick next
to "Show when program starts" (this setting can
also be made via the program menu: "Func-
tions" ± Show Color Setting...").
3) Click "OK" to close the window.
②
Window "Sign Color"
)" is
fig. 2) appears.

4.2.1 Setting the interface

Select the appropriate interface so that the pro-
gram can transfer data to the display.
1) Activate the menu item File ± Set COM... and
then, from the list, select the number of the inter-
face that the USB driver simulates for the pro-
gram.
2) Click "OK" to confirm.
The appropriate settings of the operating system
can, for example, be found under ± Control Panel
± System Properties (Hardware) ± Device Manager
± Ports (COM and LPT).
It reads, for example: "USB to UART [...] (COM3)"
If the computer has assigned a COM number higher
than 8 to the interface, the COM number must be
manually changed to a number between 1 and 8
(e. g. via ± Properties ± Port Settings ± Advanced ...).
The transmission parameters must be set for the
interface as follows (e. g. via ± Properties ± Port
Settings):
bits per seconds: 9600
data bits: 8
parity: none
stop bits: 1
flow control: Xon / Xoff
4.2.2 Entering a message and
transferring it to the display
In the text window, enter the text to be displayed
( fig. 3). The bottom of the window indicates the
number of characters that have been entered. If the
user tries to enter more than 210 characters, a
message will appear informing the user that the
maximum number of characters has been reached.
③
Main window with text
The menu allows the user to include formatting
instructions ( chapter 4.2.3), special characters
( chapter 4.2.4), date and time (
GB
chapter 4.2.5),
21