Applications; Safety Notes; Setting The Display Into Operation; Mounting - IMG STAGE LINE PML-60R Bedienungsanleitung

1 Applications

The LED displays can visualize texts and plain
graphics on a matrix of 7 × 120 LEDs (PML-100...)
or 7 × 80 LEDs (PML-60/70...). While the PML-
100R and the PML-60R only provide red LEDs, the
PML-100COL and PML70-COL allow for visualiza-
tions in red, green and orange. The displays can be
operated via the infrared remote control supplied or
via USB using a computer. Up to 26 messages can
be saved on the display. The messages may be
arranged in any order desired and may be en -
dowed with various effects to arouse attention. The
integrated clock allows for a time-controlled display
or for the display of date and time. An internal buffer
battery keeps the data entered and ensures that
the clock continues working for up to 30 days after
the power supply has been disconnected. The PC
program allows users to create their own graphics
and special characters.

2 Safety Notes

These units (display and power supply unit) corre-
spond to all relevant directives of the EU and are
therefore marked with
WARNING The power supply unit uses dange-
rous mains voltage. Leave servicing
to skilled personnel only. Inexpert
handling may result in electric shock.
Please observe the following items in any case:
G
The units are suitable for indoor use only. Protect
them against dripping water and splash water,
high air humidity and heat (admissible ambient
temperature range 0 – 40 °C).
G
Do not operate the display and immediately dis-
connect the mains plug from the socket
1. if the units or the mains cable are visibly dam-
aged,
2. if a defect might have occurred after a unit was
dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the units must be repaired by skilled
personnel.
G
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug.
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
.
G
No guarantee claims for the units and no liability
for any resulting personal damage or material
damage will be accepted if the units are used for
other purposes than originally intended, if they
are not correctly connected or operated, or if
they are not repaired in an expert way. Likewise,
no liability will be accepted for data loss caused
by operating errors or by a defect or for any con-
sequential damage of this data loss.
If the unit is to be put out of operation defi-
nitively, take it to a local recycling plant for
a disposal which is not harmful to the envi-
ronment.
3 Setting the Display
into Operation

3.1 Mounting

To mount the display to a wall, for example, use
the mounting brackets supplied. Remove the two
screws (3) located on the left and right side of the
display and then use them to fasten the display to
the mounting brackets.
Alternatively, suspend the display by means of
the two eyes (1) located on the left and right side of
the display. The eyes glide out of the display when
the display is turned.
WARNING Install
expertly. When installing the display
at a place where people may walk or
sit under it, equip its mounting with
an additional security mechanism to
prevent it from dropping or make
sure that the mounting cannot get
disengaged.
3.2 Inserting batteries into
the remote control
The battery compartment is located on the bottom
side of the remote control.
1) Press the locking latch of the battery compart-
ment in the direction of the arrow and open the
cover.
2) Insert two batteries of AA size. Observe the
polarity (indicated in the battery compartment).
3) Replace the cover and have the latch engaged.
the display safely
GB
and
17