Renkforce IO-40TB ELA Bedienungsanleitung Seite 21

Keep your own safety in mind when handling power tools (e.g. power drill). Observe all other safety
instructions in the manufacturer's instructions.
When mounting the product, make sure there are no people present below the speaker.
The following shows the installation of one speaker. Install the second speaker the same way.
Observe the following pictures for vertical and horizontal installation.
Vertical installation
Adjusting the angle.
• Steps and : Loosen the installation screw (1) on the top and bottom of the speaker and then remove the wall
mount (2) from the speaker. Select the position at the installation location. Mark the required drill holes onto the
installation surface. To do so, use the wall mount as template.
• Steps and : Drill the holes. Screw the wall mount onto the mounting surface using one washer (12 x 4 x 1)
and one screw (M4 x 36) each. It is possible to use suitable dowels (not provided). In order to do so, use a suitable
crosshead screwdriver.
and
: Position the speaker between the two sides of the wall mount. Attach them to the top and
• Steps
bottom (for vertical installation) or laterally (for horizontal installation), using one installation screw each (turn
clockwise). Do not yet fully tighten the installation screws.
Adjust the angle of the speaker. The speaker will click into one of the latching mechanisms. Then tighten the
installation screws.
Horizontal installation
Adjusting the angle.
21