C) Operating Mode "Temperature Control In Time Windows - Renkforce 1429366 Bedienungsanleitung

Up to three radio measuring switching sockets can be activated for 24-hour tempera-
ture control.
The values determined by the switching socket (Volt, Ampere, Watt) are updated in
the display of the radio measuring display/thermostat every three minutes.

c) Operating mode "Temperature Control in Time Windows"

The radio measuring display/thermostat can be used to cool or heat rooms - assuming connec-
tion of suitable devices to the switching socket. The display will show a sun for heating (heater
is connected) or a snowflake for cooling (air conditioning unit is connected). Additionally, up to
eight individual time windows can be programmed with a desired "target temperature".
Push the button "FUNC" when the radio measuring
display/thermostat is ready until you can see "Meter"
in the upper left of the display. Use the button "+/ON"
to select the switching socket (1, 2 or 3 - see figure 7)
that you want to use.
For temperature monitoring by time windows, select
the desired operating mode (heating or cooling - see
figure 8). Then push the button "FUNC" until "Auto"
appears in the display and "Setting" is shown at the
upper left.
Push the button "+/ON" or "-/OFF" to select the de-
sired memory (1 - 8).
Now push the button "FUNC" for more than three
seconds until the temperature display flashes. Then
select the desired temperature with the buttons
"+/ON" and "-/OFF". Then push the button "FUNC"
again.
The display for the weekday will now flash. Push the button "+/ON" or "-/OFF" to set the desired
day. You can also set the day blocks "Monday through Friday" or "Monday through Sunday".
Now push the button "FUNC" again. The hours for the start time will now flash in the display.
Push the button "+/ON" or "-/OFF" to set the proper number of hours.
Figure 10
31