D) Overwriting Time Windows; E) Delete Time Window; Setups And Mounting Hooks - Renkforce 1429366 Bedienungsanleitung

If a time window is to be programmed for an entire day, the start and end time must
be the same. In this case, you can program additional time windows, but these will be
ignored.
At time overlaps between time windows of a radio measuring switching socket, the
overlaps are performed as follows. Example 1: Time window 1 is programmed from
0:00 AM to 5:00 AM and time window 2 from 0:00 AM to 4:00 AM. The time window 2
is completely overwritten by time window 1 and will not be applied.
Example 2:
Time window 1 is programmed from 02:00 AM to 5:00 AM and time window 2 from
01:00 AM to 4:00 AM. In this case, the set target temperature from time window 2 is
monitored from 1:00 AM to 2:00 AM. The set target temperature from time window 1 is
monitored from 02:00 AM to 05:00 AM.

d) Overwriting time windows

A time window can be overwritten at wrong input or if changes are desired. Select the respective
time window. Push the button "FUNC" for more than three seconds and change the values as
already described in this chapter.

e) Delete time window

A time window can also be deleted completely. Select the desired time window and push the
button "-/OFF" for more than two seconds.

12. Setups and mounting hooks

The measuring display/thermostat can be set up on a base (e.g. a table) with the setup inte-
grated into the rear of the housing. Alternatively, you can use a matching screw installed in a wall
(screw not enclosed) to suspend the radio measuring display/thermostat on the eyelet integrated
in the rear of the housing.
33