Hendi 3000 Gebrauchsanweisung Seite 6

5. Stop the operation by turning the appliance to
STANDBY mode by rotating the power selector
anti-clockwise until - will be shown on the display.
Note: 1). If the cookware is removed from the ap-
pliance at any time during cooking, beep
Error codes
Error code on the display
E2, E6, E7, E8
E3
E4
E5, E9
EN
Remarks:
1. "Beep" sound will also be heard.
2. WARNING! Never try to repair yourself. Contact the service centre.
Cleaning and maintenance
• Always remove the plug from the socket before
cleaning the appliance.
• Beware: Never immerse the appliance in water or
any other liquid!
• Clean the outside of the appliance with a damp
cloth (water with mild detergent).
• Never use aggressive cleaning agents or abra-
sives. Do not use any sharp or pointed objects. Do
Technical details
AC power supply: 230-240 V~ 50 Hz
Power consumption: 3000 W
6
2). When the appliance is turn to STAND-
Possible cause
Internal circuit error:
Internal components are either over-
heating or have an open or short cir-
cuit
Cookware sensor detection
The input voltage is too high (Over 275
± 5V~).
The input voltage is too low
than 150 ± 5V~).
The temperature of the cooking plate
is too high.
not use petrol or solvents! Clean with a damp cloth
and detergent if necessary. Do not use abrasive
materials.
• Clean the fan openings with the vacuum cleaner.
• Clean the glass plate each time after use. This is to
prevent any residues from burning onto the glass
plate.
Power level: Level 1 to level 9
Temperature setting: 60°C to 240°C
sound will be heard, error code
shown on the display.
BY mode, the fan will be continue running
within 1 min.
Possible solution
Contact supplier service centre.
• Check whether or not the cookware
is suitable.
• Make sure the cookware is within the
circular cookware placement mark-
ing on the appliance.
• Cookware is removed during cook-
ing. Replace cookware back on the
appliance.
Make sure correct electrical outlet is
used: 220-240V~
(Less Make sure correct electrical outlet is
used: 220-240V~
Remove the cookware and wait until
the appliance has cooled down.
will be