Preparation For Use; During Use - Dräger Parat 4000 Series Gebrauchsanweisung

Use
4 Use
4.1

Preparation for use

NOTICE
i i
If you have a smaller head, you may need to press the half mask over
your mouth and nose for better sealing.
If you have a large head the face mask may feel slightly less comfortable.
4.1.1 Keep the escape hood ready
Before use, visually inspect the excape hood.

Do not use the escape hood if it shows damage (e.g. condensation water,
cracks, etc.). In this case, the product must be disposed of and replaced.
If the filter is deformed, e.g. by a fall, the filter performance may be impaired.
In this case, the filter must be disposed of and replaced.
Store the Dräger PARAT in its packaging within easy reach and protected against
damage, e.g., at the workplace. Avoid high temperatures and direct sunlight.
Check the expiry date on the filter. Do not manipulate the product. The seal on the
packaging must be undamaged. Memorise the Instructions for Use.
4.2

During use

WARNING
!
Only use the escape hood if it is undamaged and the seal on the device
is intact.
Dräger PARAT 4720 / 5520 / 7520 / 7520e and
Dräger PARAT 4730 / 5530 / 7530 / 7530e
Open the packaging (Figure 1 and 2 on page 2).

1. Dräger PARAT 4720 / 5520 / 7520 / 7520e
(Soft Pack):
Undo the seal.
Reach underneath the yellow clasp (Figure 1 on page 2) and pull forcefully
in the direction of the arrow until the packaging is completely open (Figure 2
on page 2).
1. Dräger PARAT 4730 / 5530 / 7530 / 7530e
(Hard Case):
Reach underneath the yellow fastener and pull forcefully in the direction of the
arrow until the packaging is completely open (Figure 2 on page 2).
The seal is broken.
2. Grasp the escape hood and pull it out forcefully, the Velcro straps are open
(Figure 3 on page 2).
14 Dräger PARAT 4000/5000/7000
en