Radio Mode; Stereo/Mono Reception - Grundig RCD 1445 USB Handbuch

RADIO MODE

Antennas
1 For FM stations (VHF) extend the telescopic antenna.
Note:
If the FM signal is too strong, it is advisable to push
7
in the telescopic antenna.
Selecting the radio input source
1 Move the »OFF CD USB
»RADIO« position.
Setting and storing radio stations
Automatic station search
1 Activate the station search by pressing
»PROG/MEM« until the frequency display
changes to rapid run-through.
– T he device searches for up to 10 radio stations
and then saves them. After the search has
finished, the station stored in position 01 can be
heard.
Automatic station search
1
Activate the station search by pressing »DOWN
or »UP « until the frequency display changes to
rapid run-through.
– T he search stops when a programme is found.
Manual station search
1 To move the frequency forward in steps, briefly press
»DOWN « or »UP
– The frequency changes in steps of 50 kHz.
_________________________________________________________
RADIO« switch to the
« several times.
Storing stations on station positions
Up to 10 stations in the FM band can be stored.
1
Press »DOWN « or »UP
2 Press »PROG/MEM« briefly to activate the memory
function.
3 Select the desired station position with
»ALBUM MEMORY
»ALBUM MEMORY
4 Press »PROG/MEM« to save the station.
5 To store more stations, repeat steps 1 to 4.
Note:
You can replace a station on a preset with a new
7
one by carrying out steps 1 to 4 as described
above.
Selecting a preset position
1 Select the station preset position with »ALBUM ME-
MORY UP« or »ALBUM MEMORY

Stereo/mono reception

If the device receives an FM stereo station, »
«
pears in the display. However, if the signal from the FM
stereo station is weak, you can improve the sound qual-
ity by switching to mono reception.
1 Switch to mono reception by pressing
MONO/ST.«.
»■
2 Switch to stereo reception by pressing
»■ MONO/ST.« again.
« to select the station.
UP« or
DOWN«.
DOWN«.
« ap-
)
ENGLISH
21