Power Supply; General Functions; Automatic Shutdown - Grundig RCD 1445 USB Handbuch

POWER SUPPLY

Mains operation
Note:
Check that the mains voltage on the type plate
7
corresponds to your local mains supply.
If this is not the case, contact your specialist dealer.
7
1 Plug the mains cable supplied into the
socket on the radio recorder (back of device).
2 Plug the mains cable into the wall socket.
Caution:
The device is connected to the mains with the po-
7
wer plug. To fully disconnect the device from the
mains, pull out the plug.
The mains plug is used to disconnect the device. It
7
shall remain readily operable and should not be
obstructed during intended use.
Battery operation
1 Open the battery compartment by pressing the catch
and removing the lid.
2 Insert six batteries (6 x 1.5 V/type IEC R14/UM2/
C-size), observing the polarity marked on the lid of
the battery compartment.

GENERAL FUNCTIONS

Switching on and off
1 Switch on the device with the required input source
by moving the switch to the
»OFF CD USB RADIO« position.
2 Move the »OFF CD USB
»OFF« position to switch off the device.
Selecting the input source
1 Select the input source (CD, USB or RADIO) using
»OFF CD USB RADIO«.
Adjusting the volume
1 Adjust the volume with »VOLUME«.
20
ENGLISH
_____________________________________________________
»AC «
~
___________________________________________
RADIO« switch to the
3
Close the battery compartment.
Notes:
Do not expose the batteries to extreme heat,
7
caused for example by direct sunlight, heaters or
fire.
Remove the batteries when they are flat or when
7
you know that the device will not be used for a
long period of time.
The manufacturer accepts no liability for damage
7
resulting from leaking batteries.
The batteries are switched off during mains op-
7
eration.
Environmental note:
Batteries, including those which contain no heavy
7
metal, may not be disposed of with household
waste. Please dispose of used batteries in an en-
vironmentally sound manner. Find out about the
legal regulations which apply in your area.
Switching the Ultra Bass System on
and off
This function boosts the bass frequencies.
1 Switch the Ultra Bass System on and off with »UBS«.
Listening with headphones
1 Connect the headphones to the »0« headphone
jack (ø 3.5 mm).
– T his switches off the loudspeakers.
Note:
Excessive sound pressure from the earphones or
7
headphones can cause hearing loss.

Automatic shutdown

If the device is in the "Stop" position for more than 15
minutes it automatically switches to Stand-by mode. For
further using switch on the device again.