Changing The Carbon Brushes; Cutting Precision Fine Adjustment - Westfalia TSH165 Betriebsanleitung

Changing the Carbon Brushes

The saw is equipped with self-isolating
special brushes. They are automatically
isolated when worn, and the tool stops.
Check the carbon brushes regularly. Replace
the carbon brushes with genuine spare parts
if they are worn to the wear limit (approx.
50% of the block). Always replace the carbon
brushes in pairs.

Cutting Precision Fine Adjustment

The cutting precision for straight cuts (90°
cuts) is factory-set. If the cutting precision
has come out of adjustment use a 3 mm hex
key to adjust the stud screws at the bottom of
the base plate to restore the cutting
precision.
1. Use a setsquare to adjust the saw
blade to the 90° angle.
2. Lay the plunge saw to the side and
set the cutting precision with the
stud screws.
The cutting precision for straight 45°
mitre cuts is factory-set.
1. Swivel the plunge saw to 45° position to set the 45° mark arrow (see circle).
2. Use a setsquare to check the angle.
3. Lay the plunge saw to the side and set the cutting precision by means of
the stud screws.
Operation
39