Inhaltsverzeichnis
Werbung
melting when cutting plastics.
Straight Cuts (90°-Cut)
1. Loosen both rotary knobs (8) and swivel the saw to 0° position on the scale.
Tighten the rotary knobs again.
2. Turn the selector switch (18) to plunge cut function.
3. Set the desired plunge depth. Ensure that the guide rail track
compensation (10) is up when using the saw without guide rail.
4. To switch on the saw press the switch lock (1) and the ON/OFF switch (2) and
push the motor down. Guide the saw forward to cut.
Making Mitre Cuts (up to 48°)
1. First loosen both rotary knobs (8) and swivel the
plunge saw to the desired graduation. Tighten the
rotary knobs again.
2. Switch the plunge saw on.
3. Turn the selector switch (18) to
the plunge cut function.
4. Set the desired plunge depth. Make sure that
the guide rail track compensation (10) is in up
position when using the saw without guide rail.
5. To switch the saw on press the switch lock (1)
and the ON/OFF switch (2) and push the motor
down. Guide the saw forward to cut.
The cutting indicator (15) shows the cutting path
for 90° and 45° mitre cuts (without using the guide
rail).
Making Marking Cuts
1. Turn the selector switch (18) to
marking cut function.
2. Press the switch lock (1) and push the motor
down. The casing stops in 2.0 mm cutting depth
position.
Note: The marking line should be aligned with
cutting line
A
Operation
(0 mark).
32
Werbung
Inhaltsverzeichnis
