Telefunken TRC 850 Bedienungsanleitung Seite 14

Safety Instructions
Before using the remote control, please read these operating instructions carefully. Please keep
the instruction manual for consultation purposes or for possibly handing it over to third parties.
General information
Do not try to repair the remote control yourself.
The universal remote control is equipped with a class 1 infrared diode.
The device is equipped with a safety system that prevents the leakage of hazardous laser beams
during normal use.
To avoid eye injury never manipulate or damage the safety system of the device.
Do not expose your remote control to dust, intense sunlight, humidity, high temperatures or
mechanical shocks.
Old and new batteries must never be combined.
Battery information
Keep batteries away from children. Consult a doctor immediately if a battery is swallowed.
Before inserting the batteries, check that the contacts in the unit are clean, and clean them if
necessary.
Only insert new batteries. Never mix old and new batteries.
Never mix battery types.
When inserting the batteries, take care that the polarity (+/–) is correct.
CAUTION! Danger of explosion if the batteries are replaced incorrectly. Only replace the
batteries with ones of the same or equivalent type.
Never attempt to recharge the batteries. Explosion hazard!
Store batteries in a cool dry place. Excessive direct heat may damage the batteries. Therefore,
never expose the unit to strong sources of heat.
Never short circuit the batteries.
Never throw batteries into a fire.
Remove the batteries if the unit is not to be used for long periods.
Remove leaking batteries from the unit immediately. Clean the contacts before inserting new
batteries. Battery acid may cause burns!
Remove empty batteries from the unit
Cleaning
Clean your remote control with a dry cloth only, do not use any corrosive or aggressive cleaning
agents.
Inserting the batteries
Insert 2 LR03/AAA alkaline batteries
1. Open the cover on the back of the remote control.
2. Check the +/– polarity on the batteries and inside the compartment.
3. Insert the batteries.
4. Close the cover.
Adjustments after battery replacement
If the batteries are correctly inserted, the LCD screen should display the active mode (e.g. TV),
the week day and the time. For adjusting Time and Date, please read further in this manual.
After battery replacement, the time, the date and LCD backlight are reset to factory defaults, all
other User programmed parameters including programmed codes and learning functions are
retained indefinetly.
This universal remote control can control up to 8 different Audio/Video devices and is compatible
with the majority of television sets, DVD players and video recorders, as well as digital boxes
such as satellite or cable receivers, DVBT receivers (Digital Video Broadcast Terrestrial), ADSL
decoders, and so on.
Except for the TV mode key, the DVD, VCR, SAT, CBL, AMP, AUX1 and AUX2 mode keys can be
programmed to control a device other than that indicated on the key. It is therefore possible, for
example, to allocate SAT mode to the DVD key. You must enter the code corresponding to the
manufacturer and the device by using one of the methods indicated in this manual.
14