Arrifana 08C
HEAT MODE*
Press the " " button a number of times until the " " symbol appears.
Select the target temperature (13-27°C) by pressing the " " or " " button until the
corresponding value is displayed.
In heating mode, the fan speed is selected automatically by the appliance.
Water is removed from the air and collected in the tank.
When the tank is full, the appliance shuts down and " " (full tank) appears on the display.
The tank cap must be extracted and emptied (Reference "Intermittent drainage section").
Run off all water left into a basin. When all the water has been drained, put the cap back in
place.
When the tank has been emptied, the appliance starts up again.
N.B.
When operating in very cold rooms, the appliance defrost automatically,
momentarily interrupting normal operation. " " appears on the display. During
this operation, it is normal for the noise made by the appliance to change.
In this mode, you may have to wait for a few minutes before the appliance starts
giving out hot air.
In this mode, the fan may operate for short periods, even though the set
temperature has already been reached.
"*" means only the heat pump model have this function.
www.blaupunkt.com
16