Operation; Specifications - IMG STAGE LINE WSA-20BT Bedienungsanleitung

other purposes than originally intend-
ed, if they are not correctly connected
or operated, or if they are not repaired
in an expert way .
If the units are to be put out
of operation definitively, take
them to a local recycling plant
for a disposal which is not
harmful to the environment .

4 Operation

1) Find a suitable position for the receiv-
er, then set the receiver up, screw it
on or attach its holding magnets to a
magnetic surface . Put the antenna (2)
in a vertical position .
2) Use an audio cable to connect the
6 .3 mm jacks OUTPUT (3) to the in-
put (e . g . LINE, CD, AUX) of the audio
system .
3) Connect the power supply unit pro-
vided to the jack AC 9V~ (1) and to
a mains socket (230 V~/50 Hz) . The
button PAIR (4) will briefly flash at
intervals .
4) Activate the pairing mode: Keep the
button PAIR pressed for 3 seconds so
that the button starts flashing contin-
uously .
5) As long as the button PAIR keeps
flashing continuously (for 1 minute),
activate the Bluetooth function at
the Bluetooth signal source and pair
the signal source with the WSA-20BT
(refer to the manual of the signal
source) . If a PIN code is requested, en-
ter "0000" .
Once the Bluetooth signal source
has been paired with the WSA-20BT,
the button PAIR will light continuously .
6) Start the audio reproduction at the
signal source and adjust the volume .
Readjust the volume at the audio sys-
tem, if required .

5 Specifications

Audio frequency range: � � 20 – 20 000 Hz
THD: � � � � � � � � � � � � � � � � < 0�01 %
Channel separation:� � � � � ≥ 75 dB
Output
Level: � � � � � � � � � � � � � � line level
Connection: � � � � � � � � � 6�3 mm jack, bal�
Bluetooth
Version: � � � � � � � � � � � � V 2�1 + EDR
Profiles: � � � � � � � � � � � � A2DP 1�2
Transmission frequency: 2�40 GHz – 2�48 GHz
Receiver sensitivity: � � � � –80 dBm
Range: � � � � � � � � � � � � � 10 – 20 m,
Power supply: � � � � � � � � � 9 V~ via
Dimensions w/o antenna: 116 × 35 × 86 mm
Weight: � � � � � � � � � � � � � � 117 g
Subject to technical modification .
All rights reserved by MONACOR
TIONAL GmbH & Co. KG. No part of this instruc­
tion manual may be reproduced in any form or by
any means for any commercial use.
AVCTP 1�0
1�0 1�0111111
AVDTP 1�0
AVRCP 1�0
GAVDP 1�2
depending on the
signal source
power supply unit
provided, connected
to 230 V~/50 Hz
INTERNA­
®
7