Applications; Conformity And Approval; Setting Into Operation; Setting Up, Connecting And - IMG STAGE LINE TXS-707 Bedienungsanleitung

DC INPUT OUTPUT (BAL.)
7 8 9
•
No guarantee claims for the units and no li-
ability for any resulting personal damage or
material damage will be accepted if the units
are used for other purposes than originally
intended, if they are not correctly connected
or operated, or if they are not repaired in an
expert way.
If the units are to be put out of oper-
ation definitively, take them to a local
recycling plant for a disposal which is
not harmful to the environment.

3 Applications

Combine the receiver TXS-707 with a wireless
microphone to provide a wireless audio trans-
mission system specially designed for musicians
and live applications on stage. The True Diver-
sity* receiver uses the UHF frequency range
667.000 – 691.750 MHz.
*True Diversity technology:
The signal sent from the wireless microphone / pocket
transmitter is received by two antennas and amplified in
two separate receiver sections. The signal of the highest
power is then processed.
The following transmitters can be operated
together with the TXS-707:
Model Type
Pocket transmitter with mini XLR
TXS-707HSE connection for tie clip microphones
and headband microphones
TXS-707HT Hand-held wireless microphone
Pocket transmitter with
TXS-707LT
tie clip microphone
Setting the transmission channel is most conven-
ient: Just set the channel at the receiver; via an
infrared signal from the receiver, the transmitter
will then be set to the same channel.
OUTPUT (UNBAL.) ANT-B
10

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the receiver TXS-707 complies with the
directive 1999 / 5 / EC. The EU declaration of con-
formity is available on the Internet:
www.imgstageline.com
The microphone may be operated in the fol-
lowing countries:
DE
Prior to operating the receiver outside Germany,
please contact the MONACOR subsidiary or
the corresponding authorities of the respective
country. Links to the national authorities can be
found via the following Internet address:
www.cept.org
t ECC
t Topics / Info
t SRD* Regulations and indicative list of equipment
sub-classes
t Tools and Services
t EFIS – ECO Frequency Information System
t National Frequency Tables
*Short Range Devices

4 Setting into Operation

4.1 Setting up, connecting and

1) The receiver can be placed on a table or in-
stalled into a rack (482 mm /19").
mounting brackets supplied onto the left
and right sides of the housing. In the rack,
the receiver requires 1 RS (RS = rack space
= 44.45 mm).
2) Connect the two receiving antennas supplied
to the antenna jacks ANT-A and ANT-B (11).
To lock the antennas, turn the knurled ring
11

switching on /off the receiver

For rack installation, screw the two
ANT-A
9