Modster 200 Charger Duo Benutzerhandbuch Seite 26

Manual
8.2 NiCd/NiMH Batteries
In the program select menue on the screen, use the STOP key to select NiCd or NiMH battery type and then press the START key.
By pressing the arrow keys, you can select the different function modes:
NiMH CHARGE Man: Man normal charge
NiMH CHARGE Aut: Aut normal charge, auto charge current up to the user limit
NiMH DISCHARGE: Discharge the battery
NiMH CYCLE: Cycle the battery
Modifying the settings:
To modify the charge settings, press the START key so that the charge current blinks. Use the arrow keys to increase or decrease the charge
current.
To modify the discharge settings, press the START key so that the discharge current or discharge end voltage starts to blink. Use the arrow keys
to increase or decrease the discharge current or the discharge end voltage (0.1V-25.0V).
The cycle mode uses the current charge and discharge settings.
Launching the charge or discharge:
Once you are ready to start the charge, discharge or cycling, press and hold the START key for 3 seconds.
CHG: normal charge mode
DSC: discharge mode
D>C: discharge-charge cycle
D<C: charge-discharge cycle
While the charger is charging or discharging the battery, you can modify the running charge and discharge current by pressing the START
key and using the arrow keys. Then press the START key again. You can use the arrow keys to change the information displayed the screen.
Once the charger has determined that the charge or discharge is complete, the charger stops and the FULL or END message is displayed.
26
MODSTER 200 Charger Duo
www.modster.at