Proper Use; Symbols On The Machine; Safety Instructions - Kärcher HD 7/17-4 Cage Originalbetriebsanleitung

Proper use

Use the devices exclusively for
For cleaning using high pressure jet
–
without detergent (for e.g. for cleaning
facades, terraces, garden appliances).
with detergent valve mounting kit:
–
Cleaning using low pressure jet and de-
tergent (for e.g. for cleaning machines,
cars, buildings, tools),
For stubborn dirt, we recommend the use of
the dirt blaster as a special accessory.

Symbols on the machine

High-pressure jets can be dan-
gerous if improperly used. The
jet may not be directed at per-
sons, animals, live electrical equipment or
at the appliance itself.
According to the applicable regu-
lations, the appliance must never
be used on the drinking water net
without a system separator. Use a
suitable system separator manufactured by
Kärcher; or, as an alternative, a system
separator as per EN 12729 Type BA.
Water flowing through a system separator
is considered non-drinkable.
Risk of burns on account of hot
surfaces!

Safety instructions

Please follow the national rules and
–
regulations for fuel spray jets of the re-
spective country.
Please follow the national rules and
–
regulations for accident prevention of
the respective country. Fuel spray jets
must be tested regularly and the results
of these tests must be documented in
writing.
Danger
Risk of injury!
Only use original high-pressure hoses.
–
14
The high-pressure hose and the injec-
–
tion system must be suitable for the
maximum operating pressure given in
the Technical Data.
Avoid contact with chemicals.
–
Check the high-pressure hose daily.
–
Do not use hoses with kinks.
Stop using the high-pressure hose if the
external wire layer is visible.
Do not use the high-pressure hose any-
–
more if the winding is damaged.
Lay the high-pressure hoses in such a
–
way that no vehicle can drive over it.
Do not use high-pressure hoses that
–
have been driven over, kinked, pressed
or bent even if there is no externally vis-
ible damage.
Store the high-pressure hoses in such a
–
way that they are not subject to any me-
chanical load.
Overflow valve
When the lever of the hand spray gun is re-
leased, the overflow valve switches to cir-
cuit operation. The water flows back to the
suction side of the pump.
Thermostat valve
The thermal valve protects the high-pres-
sure pump from unacceptable heating dur-
ing circuit operation.
The thermo-valve opens when the permis-
sible water temperature is exceeded and
lets out the hot water into the open.
Thus, cold water will follow and cool the
pump.
– 2
EN