Installation - Stiga Park Gebrauchsanweisung

GB
SYMBOLS
The following symbols can be found on the
machine to remind you of the care and attention
that are required during use.
The symbols mean:
Warning!
Read the instruction manual and the safety
manual before using the machine.
Warning!
Do not insert your hands or feet under the
cover when the machine is in operation.
Warning!
Watch out for discarded objects. Keep
onlookers away.
Warning!
Before starting repair work, remove the
spark plug cable from the spark plug.
PREPARATIONS
Park, year models up to and including 1993:
In order for the deck to be used, the machine has to
be modified:
1. Remove the return spring for the articulated
joint
(fig. 1).
2. Saw off the spring mount flush with the frame
side member
(fig. 2).
3. Drill a new hole (Ø 8 mm), 8 mm from the lower
edge of the frame side member (fig. 3).
4. Install the spring in the new hole (fig. 4).
INTRODUCTION
107 M
This cutting deck is available as standard in two
versions:
- with mechanical setting of the cutting height
(item no. 13-2927).
- with factory-fitted, electrical setting
of the cutting height (item no. 13-2935).
20
ENGLISH

INSTALLATION

DECK ARMS
1. Install the left and right deck arms in the cutting
deck's front two corners. Use the existing screw
and flat washer (fig. 5). Tighten the screw. After
tightening, it should be possible to move the deck
arms up and down.
2. Do not hook the rear part of the deck arms onto
the deck yet (See "Cutting deck" point 4 below).
CUTTING DECK
1. Place the cutting deck in front of the machine.
Set the maximum cutting height.
2. Thread one of the deck arms onto the machine's
steering knuckle (fig. 7). Place the flat washer on
the steering knuckle and secure with a locking pin.
Repeat on the other side.
3. Force the V-belt onto the machine's centre
pulley (fig. 10).
4. Lift up the deck's rear part past the catch until it
drops down. When the weight of the deck is resting
on the upper side of the catch, the installation is
correct (fig. 8).
5. Tension the belt with the belt idler. The belt idler
should be on the left side of the belt viewed from
the driver's position (fig. 10).
6. Park –1999:
Hook the belt idler spring in the floor on the right
side (fig. 10).
7. Attach the lift spring to the implement lifter
(fig. 9).
8. Connect the electrical contact to the socket on
the side of the machine (only applies to item no.
13-2935).
SETTING
In order for the deck to cut evenly and attractively,
it has to be correctly adjusted:
1. Make sure the air pressure in the tyres is correct:
Front: 0.6 bar (9 psi).
Rear: 0.4 bar (6 psi).
2. Place the machine on a level floor. Undo the
screws on either side of the deck (fig. 11).
3. On the side of the deck arm are four short and
two long lines. The upper long line (A) is the basic