Declaration Of Conformity - Bosch PKS 55 A Originalbetriebsanleitung

OBJ_BUCH-841-004.book Page 23 Wednesday, January 28, 2009 11:24 AM
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
24.09.2008
Assembly
Mounting/Replacing the Saw Blade
Before any work on the machine itself, pull
the mains plug.
When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
Only use saw blades that correspond with
the characteristic data given in the operat-
ing instructions.
Do not under any circumstances use grind-
ing discs as the cutting tool.
Bosch Power Tools
Selecting a Saw Blade
An overview of recommended saw blades can
be found at the end of this manual.
Removal of the Saw Blade (see figure A)
For changing the cutting tool, it is best to place
the machine on the face side of the motor hous-
ing.
– Press the spindle lock button 4 and keep it
pressed.
The spindle lock button 4 may be actuated
only when the saw spindle is at a standstill.
Otherwise, the power tool can be damaged.
– With the Allen key 6, unscrew the clamping
bolt 17 turning in rotation direction
– Tilt back the retracting blade guard 11 and
hold firmly.
– Remove the clamping flange 18 and the saw
blade 19 from the saw spindle 21.
Mounting the Saw Blade (see figure A)
For changing the cutting tool, it is best to place
the machine on the face side of the motor hous-
ing.
– Clean the saw blade 19 and all clamping
parts to be assembled.
– Tilt back the retracting blade guard 11 and
hold firmly.
– Place the saw blade 19 on to the mounting
flange 20. The cutting direction of the teeth
(direction or arrow on saw blade) and the di-
rection-of-rotation arrow on the blade guard
15 must correspond.
– Mount the clamping flange 18 and screw in
the clamping bolt 17 turning in rotation di-
rection . Observe correct mounting posi-
tion of mounting flange 20 and clamping
flange 18.
– Press the spindle lock button 4 and keep it
pressed.
– With the Allen key 6, tighten the clamping
bolt 17 turning in rotation direction
tightening torque is between 6–9 Nm, which
corresponds to hand tight plus ¼ turn.
1 609 929 S13 | (28.1.09)
English | 23
.
. The