Technical Data; Declaration Of Conformity; Battery Charging - Bosch Professional GKS 18 V-LI Originalbetriebsanleitung

OBJ_BUCH-755-003.book Page 23 Wednesday, December 16, 2009 9:18 AM

Technical Data

Circular Saw
Article number
Rated voltage
No-load speed
Cutting depth, max.
– for 0° bevel angle
– for 45° bevel angle
Spindle lock
Base plate dimensions
Saw blade diameter,
max.
Saw blade diameter,
min.
Blade thickness, max.
Tooth thickness/
setting, max.
Tooth thickness/
setting, min.
Mounting bore
Weight according
to EPTA-Procedure
01/2003
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Bosch Power Tools
Dr. Egbert Schneider
Senior Vice President
Engineering
GKS 18 V-LI
Professional
3 601 F6H 0..
V= 18
Robert Bosch GmbH, Power Tools Division
-1 D-70745 Leinfelden-Echterdingen
min 3900
12.11.2009
mm 51
mm 40
Assembly
mm 146 x 272

Battery Charging

mm 165
mm 160
mm 1.7 Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
mm 2.6
fore using your power tool for the first time.
The lithium ion battery can be charged at any
mm 2.0
time without reducing its service life. Interrupt-
mm 20
ing the charging procedure does not damage the
battery.
The lithium ion battery is protected against
kg 4.1
deep discharging by the "Electronic Cell Protec-
tion (ECP)". When the battery is empty, the ma-
chine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
chine has been automatically switched off. The
battery can be damaged.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
Observe the notes for disposal.
Dr. Eckerhard Strötgen
Head of Product
Certification
Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Do not continue to press the
WARNING
On/Off switch after the ma-
1 609 929 T86 | (16.12.09)
English | 23