Operation; Troubleshooting - Klarstein 10030041 Bedienungsanleitung

1. Use AC power supply. Install the water tank into the dehumidifier. Plug the DC plug into the DC port of
the appliance and the adaptor in to the socket outlet. The power light will turn on (blue) and the fan will
continuously run.
2. Press the on/off button. If the red indicator lights on, please check, if the water tank is in correct position.
3. This dehumidifier will stop the dehumidification automatically, if the water reaches the level and the red
indicator will turn on, which means the water tank is full. Please cut off the power supply, before you take
out the tank. Remove the black drain cover of the water tank and discard the collected water. Then replace
it.
4. Wipe and dry the water tank and the dehumidifier.
Indicator lamp status
Blue light
Red light.
Red light blinks every 5 seconds.
Blue light blinks every 3 seconds.
Red light every 3 seconds.
Problem
After connecting, the red
indicator lights up
The dehumidifier does not
work

Operation

Appliance runs normally.
Full water tank.
The ambient temperature is over 40 °C or under 5 °C.
The ambient temperature is between 5°C to 15 °C, the dehumidifier
will defrost automatically.
The fan, refrigeration slice or other parts have problems,

Troubleshooting

Possible Cause
The water tank is full
The float gets jammed
The power supply is cut off
DC switch is OFF
The air outlet is blocked
Solution
Empty the water tank and replace it
in correct position
Press the float and replace the water
tank
Check if the adaptor is plugged in
Turn the switch on
Maintain the minimum clearance at
least 10cm around the dehumidifier
when the unit is operating
8