Filling The Water Reservoir; Steam Ironing - Beko SGA7126P Bedienungsanleitung

3 Operation
In order to use dry ironing, do not press the steam
trigger (12).

3.6 Filling the water reservoir

WARNING: When filling the
A
water reservoir with water without
removing the iron from the steam
station, ensure that the appliance is
unplugged.
1. Press the on/off button (11), switch off and
unplug the appliance.
2. Remove the water reservoir (5) by pressing the
water reservoir removal latch placed under the
water reservoir.
3. Open the water refill lid (6) and fill water up to
the MAX level.
Your appliance is suitable for using
C
with tap water. If your tap water is
excessively hard, we recommend
you to use a mixture of tap water
and potable water.
4. Place the water reservoir (5) in its place.
– You will hear a click when the water reservoir
fits into its place.
Steam Station / User Manual

3.7 Steam ironing

1. Fill the water reservoir (5) with water (see 3.6).
2. Place the appliance on the steam station
surface (7).
3. Plug in the appliance.
– You will hear a beeping sound when the
appliance starts to operate.
– Control panel (10) flashes once and then goes off.
4. Press the on/off button (11).
C
Operation of the pump may make
some noise during the water
drawing process; this is normal.
The appliance starts in Smart-ECO
C
mode in the initial use. This level
offers safe temperature and steam
amount for all the fabrics that can
be ironed.
5. You can set temperature levels other than the
Smart - ECO mode by using the control button
(11) (see 3.4).
A
WARNING: Your selection should
be suited for the fabric to be ironed.
6. When the symbol of the selected setting flashes
consistently on the display, your appliance is
ready to iron.
WARNING: If the symbol on the
A
display blinks, this means that the
soleplate temperature setting is not
at the desired level.
C
You can do steam ironing by
using the steam trigger (12) at all
temperature levels except for "•".
7. When the appliance is ready for steam ironing,
move the iron horizontally on the fabric to be
ironed and press the steam trigger (12). Your
iron will raise steam from its soleplate (8) as
long as you hold the steam trigger pressed.
8. When the ironing process is over, press the on/
off button (11) for a few seconds.
– The lights on the control panel will go off.
9. Unplug the appliance and leave it to cool.
9 / 104 EN