Bosch GSH Professional 388 Originalbetriebsanleitung Seite 16

OBJ_BUCH-142-003.book Page 16 Tuesday, August 3, 2010 4:41 PM
16 | English
The vibration emission level given in this informa-
tion sheet has been measured in accordance with
a standardised test given in EN 60745 and may be
used to compare one tool with another. It may be
used for a preliminary assessment of exposure.
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
Declaration of Conformity
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC, 2000/14/EC.
2000/14/EC: Guaranteed sound power level
105 dB(A). Conformity assessment procedure
according to Annex VI.
Equipment category: 10
Notified body:
TÜV NORD CERT GmbH & Co. KG,
Am TÜV 1, 30519 Hannover
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
16.07.2010
1 609 929 V47 | (3.8.10)
Assembly
Before any work on the machine itself, pull
the mains plug.
Auxiliary Handle
Operate your machine only with the auxilia-
ry handle 6.
The auxiliary handle 6 can be set to any position
for a secure and low-fatigue working posture.
Turn the bottom part of the auxiliary handle 6 in
counterclockwise direction and swivel the auxil-
iary handle 6 to the desired position. Then
retighten the bottom part of the auxiliary handle
6 by turning in clockwise direction.
Changing the Tool
With the SDS-max tool holder, simpler and eas-
ier tool changing is possible without additional
aids.
The dust protection cap 1 largely prevents the
entry of drilling dust into the tool holder during
operation. When inserting the tool, take care
that the dust protection cap 1 is not damaged.
A damaged dust protection cap should be
changed immediately. We recommend hav-
ing this carried out by an after-sales service.
Inserting (see figure A)
Clean and lightly grease the shank end of the
tool.
Push back the locking sleeve 2 and insert the
tool in a twisting manner into the tool holder.
Release the locking sleeve 2 again in order to
lock the tool.
Check the latching by pulling the tool.
Removing (see figure B)
Push back the locking sleeve 2 and remove the
tool.
Bosch Power Tools