Specifications - Makita GA4030 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Shaft lock
2-1. Switch lever
4-1. Wheel guard
4-2. Screw
4-3. Bearing box
5-1. Wheel guard
5-2. Bearing box
5-3. Screw
5-4. Lever

SPECIFICATIONS

Model
Depressed center wheel diameter
Spindle thread
Rated speed (n)/No load speed (n
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Model GA4030
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
6-1. Screw
6-2. Lever
7-1. Lock nut
7-2. Depressed center grinding
wheel/Multi-disc
7-3. Inner flange
8-1. Lock nut wrench
8-2. Shaft lock
10-1. Lock nut
)
0
noise level determined
) : 85 dB(A)
pA
) : 96 dB(A)
WA
value (tri-axial vector
2
) : 7.0 m/s
h,AG
2
GA4030
100 mm
M10
-1
11,000 min
266 mm
1.7 kg
ENE048-1
Model GA4530
Work mode : surface grinding
Vibration emission (a
ENF002-2
Uncertainty (K) : 1.5 m/s
Model GA5030
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENG905-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
The declared vibration emission value is used for
•
main applications of the power tool. However if the
power tool is used for other applications, the
ENG900-1
vibration emission value may be different.
sum)
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
3
10-2. Abrasive cut-off wheel/
diamond wheel
10-3. Inner flange
10-4. Wheel guard for abrasive cut-off
wheel/diamond wheel
11-1. Exhaust vent
11-2. Inhalation vent
GA4530
115 mm
M14
-1
11,000 min
266 mm
1.8 kg
/II
) : 7.5 m/s
h,AG
2
) : 8.5 m/s
h,AG
2
GA5030
125 mm
M14
-1
11,000 min
266 mm
1.8 kg
2
2
ENG902-1