Before Use; Setting The Water Softener - Atag VA4011MTUU Bedienungsanleitung

Before use

Before using your dishwasher for the first time:
1. Ensure that the electrical and water connections
comply with the installation instructions
2. Remove all packaging from inside the appliance
3. Set the water softener
4. Pour 1 litre of water inside the salt container and
then fill with salt
5. Fill the rinse aid dispenser.

Setting the water softener

The dishwasher is equipped with a water softener
designed to remove minerals and salts from the water
supply, which would have a detrimental or adverse
effect on the operation of the appliance.
The higher the content of these salts, the harder your
water is.
Water hardness is measured in equivalent scales,
German degrees, French degrees and PPM (parts per
Million).
The softener should be adjusted according to the
hardness of the water in your area. Your local Water
Authority can advise you on the hardness of the water
in your area.
The dishwasher is factory set at level 3.
If this level is not suitable for your area the softener
should be adjusted.
You may change the factory level setting by means of
the wash programme selector push buttons. each
button corresponds to a different level.
If your water is level 1 it is already soft
and therefore there is no need to use salt.
With the setting of the water softener at
level 1 the salt indicator light on the
control panel will always remain off.
To set a different level proceed as follows:
1. Press "Intensive 70°" and "50 Bio" programme
push buttons simultaneously for about 5 seconds.
The indicator light corresponding to the current
level flashes.
2. Press within 5 seconds the programme push
button corresponding to the required level. After 5
seconds the dishwasher will memorise the new
level setting and will return to programme setting
mode.
The setting will remain memorised after switching
off the dishwasher.
Water hardness
German
Level
degrees
0 - 4
1
5 - 11
2
12 - 22
3
23 - 39
4
40 - 50
5
Level 1 = programme push button "Rinse and Hold"
Level 2 = programme push button "Intensive 70°"
Level 3 = programme push button "Normal 65°"
Level 4 = programme push button "50° Bio"
Level 5 = programme push button "Quick 50°"
49
French PPM
degrees (Parts per
(°TH) Million)
0 - 80
0 - 8
9 - 20 81 - 200
201 - 400
21 - 40
41 - 70 401 - 700
701 - 900
71 - 90
Use of
salt
NO
YES
YES
YES
YES