Herunterladen Inhalt Inhalt Diese Seite drucken

DeLonghi F622 Gebrauchsanweisung Seite 2

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 9
5725105300 F620-622
4-12-2000 15:12
End of frying time
When the selected frying time is elapsed, rifit basket
handle (fig. 4) and check that food is golden brown
as desired.
In the models fitted with a viewing window this check
can be carried out by looking through the window
without opening the lid.
When the food is
completely cooked, switch the
appliance off by setting the thermostat control to
"Off" until the switch is heard to click off. Leave the
contents to drip for a moment and then open the lid
and remove the basket without shaking it too vigo-
rously.
For two-stage frying (e.g. potatoes), lift the basket at
the end of the first stage, wait for the indicator light to
go off and then lower the basket into the oil a second
time (see enclosed table).
FILTERING OF OIL OR FAT
It is advisable to filter the oil or fat after frying in order
to remove any food particles, especially if the food is
coated in breadcrumbs or flour. Food particles remai-
ning in the oil tend to burn, which causes the oil to
deteriorate more quickly.
1. Remove the lid (fig. 5) and empty the tank from one
of its sides (fig. 6 – left or right side edge of the
tank).
2. Use a sponge or a paper kitchen towel to remove
any deposits from the bowl.
3. Hook the basket to the bowl and place the sup-
plied paper filter in the bottom of the basket (fig.
7). Spare filters can be obtained from your dealer
or from our service centres.
4. Pour the oil very slowly into the basket, ensuring
that it does not overflow from the filter (fig. 8).
Note:After filtering the oil, it can be left in the fryer.
However, should a long period of time pass
between one frying and the next, it is advisable
to store the oil in a closed container, not expo-
sed to direct light in order to avoid its deteriora-
tion. Oil used for frying fish should be stored
separately from oil used for other foods.
If fat is used for frying, this should not be
allowed to cool too much, otherwise it may soli-
dify.
Pagina 5
CHANGING THE ANTI-ODOUR FILTERS
With time the odour-eater filters placed inside the lid
lose their effectiveness. A change of colour in the filter,
visible through hole of fig.9 on the inside cover, shows
that the filter needs to be changed. To replace it, remo-
ve plastic filter cover (fig.10) by pressing hook in the
direction of arrow 1, then raise it in the direction of
arrow 2. Replace the filters.
Note: The white filter must be inserted first with the black
filter on top. The filter cover must be placed over the
black filter (fig. 11).
CLEANING
Before cleaning, always remove the plug from the
electrical socket.
Never immerse the deep fryer in water or hold it
under the tap. By getting inside the water would
cause short circuiting.
The lid is removable, to take it off, proceed as follows:
push the lid back (see arrow "1" fig. 5 ) and at the
same time, lift it up (see arrow "2" fig. 5 )
Do not immerse the lid in water without having first
removed the filters.
To clean the boiler pan, proceed as follows:
• Check that the oil is sufficiently cold (wait about 2
hours), then empty out the oil or fat as previously
described in the paragraph headed "filtering the oil
or fat".
• Remove any deposit from the bottom of the bowl
using a sponge or a paper towel.
• Wash the tank with hot water and washing up
liquid, then rinse and empty the tank from one of
the sides, as shown in fig. 6.
• We advise regular cleaning of the basket, with care
being taken to eliminate any deposits.
• The basket can be washed in a dishwasher.
• After frying, wipe the outside of the fryer with a
soft damp cloth in order to remove any oil smears
and condensation.
MODEL WITH NON-STICK BOILER PAN
To clean the boiler pan use a soft cloth with a neutral
detergent never using objects or abrasive detergents.
5

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

F620

Inhaltsverzeichnis