What To Do If; Installation - Zanussi ZOU364 Benutzerinformation

Clean the glass panel with water and soap. Dry the glass
panel carefully.
Installing the door and the glass panel
When you install the panel with a decorative frame, make
sure that the screen-printing zone looks to the inner side
of the door. Make sure that after the installation the sur-
face of the glass panel frame on the screen-printing zones
is not rough when you touch it.
Make sure that you install the internal panel of glass in the
seats correctly (refer to the illustration).

What to do if...

Warning! Refer to "Safety information" chapter.
Problem
The cooking zones do not
operate.
The appliance does not heat
up.
The oven lamp does not op-
erate.
Steam and condensation set-
tle on the food and in the ap-
pliance.
If you cannot find a solution to the problem yourself, con-
tact your dealer or the service centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

Installation

Warning! Refer to "Safety information" chapter.
26
Possible cause
The appliance is deactivated.
The fuse in the fuse box is re-
leased.
The oven lamp is defective.
You left the dish in the appliance
for too long.
Refer to the user manual for the hob.
Activate the appliance. Refer to "Daily use".
Do a check of the fuse. If the fuse is released
more than one time, contact a qualified electri-
cian.
Replace the oven lamp.
Do not let the dishes to stay in the appliance for
more than 15-20 minutes after the cooking ends.
The necessary data for the service centre is on the rating
plate. The rating plate is on the front frame of the oven
cavity.
.........................................
.........................................
.........................................
Building Under
Warning! Only a qualified and competent person
must do the installation of the appliance. If you do
Remedy