Electrical Connection - Scholtes Axiom FX36.1XA Bedienungsanleitung

The marking corresponds to the application of the following directives:
• electromagnetic compatibility EC/89/336
• marking EC/93/68
• low voltage directive EC/73/23
Before making the connection, check the mains electricity supply available:
• single-phase connection,
• voltage: 230 V or 240 V,
• fuse: 16 A,
• minimum cross-section of wires: 1.5 mm².
Your oven is delivered fitted with a 3-wire power supply cable (each wire has a cross-section of 1.5 mm²) and should be
connected to the 230V or 240V single-phase connection. The yellow/green wire is connected to the earth connection
of the appliance. The oven neutral (blue wire) should be connected to the mains neutral terminal.
If the appliance installation is achieved by means of a junction box, an omnipolar circuit breaker with a minimum contact
opening of 3 mm should be installed on the power supply side.
Make sure the electricity socket is accessible for any future maintenance work.
Important:
- Unplug the appliance before all operations, even when replacing the oven lamp.
- Using the appliance without the correct earth connection is highly dangerous.
Note:
The power supply cable can be changed. This should be done by an authorised fitter or equivalent qualified technical
serviceman.
Make sure the power supply cable is long enough to allow for any future maintenance work to be performed easily.
Only use HAR-H05-RRF quality cables fitted with a plug conforming to the regulations in force.
After connecting the appliance to the flexible cable, tighten all the screws on the terminal board.
The point of installation for the appliance must comply with NFC 15100.

Electrical connection

Electrical connections
N L
L2 L1
Voltage Frequency
FR-AT-BE-DE-GP-ES-IE-IL-IS-IT-DK
LU-RE-FI-GB-GR-PT-SE-MA-NZ-NL
230 V-1+N ~ 50 Hz
CY-MT-AU-NZ-KW
240 V-1+N ~ 50 Hz
FR-BE-NO
230 V-2 ~ 50 Hz
- 26 -
Fuse
Section
16 A
1,5 mm²
16 A
1,5 mm²