Troubleshooting - DeDietrich DOP499 Serie Bedienungsanleitung

99634051_ML_A.qxd 18/05/04

Troubleshooting

If you're not sure that your oven is working properly, it doesn't necessarily
mean that there's a problem. In all cases, check the following points:
I
f you realize that..
The oven isn't heating
The light inside the oven isn't
working.
The cooling fan keeps working
after the oven is turned off.
Pyro-cleaning doesn't start.
The door lock during pyro-clea-
ning isn't working.
The rotisserie spit keeps tur-
ning after the end of cooking.
Smoke is being produced du-
ring cooking.
There's no light inside the oven
while the pyro-clean program is
operating.
There's a noise inside the oven
after the end of cooking.
In all cases, if you are unable to solve the problem yourself, please contact the After-Sales Ser-
vice without delay.
13:06 Page 43
P
ossible causes
- The oven isn't connected to the
power supply.
- The fuse has blown.
- The temperature selected is too low.
- Other causes.
- The lamp is unusable.
- The oven isn't connected to the power
supply or the fuse has blown.
- The fan should stop after no longer
than 1 hour, as soon as the tempera-
ture of the oven falls to approx.125°C.
- If it has not stopped after 1 hour
- The door isn't shut properly.
- The clock time on the programmer is
flashing.
- Other causes.
- The lock is not effective immediately.
- The door lock only becomes effecti-
ve approx. 2 minutes after the start of
the cycle.
- The rotisserie spit motor keeps wor-
king until the selector is returned to
the zero setting, or the door is ope-
ned, or 30 minutes after the end of
the cooking time.
This program avoids the food burning
once the oven has stopped.
- 1. Cooking temperature too high
- 2. Dirty oven
- The lighting is only meant to come on
for the cooking programs.
- The fan in the upper part of the oven
(not visible) is working (even if the
oven is set to the "off" position).
W
hat should you do?
- Connect to power supply.
- Change the fuse, checking that it
is 16A.
- Increase the temperature selec-
ted.
- Contact the After-Sales Service.
- Change the bulb.
- Connect to power supply or
change fuse.
- Nothing.
- Contact the After-Sales Service.
- Make sure the door is closed cor-
rectly
- Set the hour of the day before
starting up the pyro-clean.
- Call the After-Sales Service.
If it hasn't locked after 5 minutes,
contact the After-Sales Service.
- Nothing
- 1. Reduce the cooking
temperature (see cooking guide).
- 2. Clean the oven by pyro-clea-
ning if this program is available.
- The pyro-clean cycle produces tempe-
ratures, which are too high for the ligh-
ting to work properly.
- This is normal; the fan of a pyro-
clean oven stays on until the oven
has cooled down.
43
GB